Gerber to CAD

Our Editing Services are broken down into five categories. Each category is further broken down into their specific data requirements.

Category	Data Requirements
Automated (Preferred)	Gerber + IPC-D-356 Netlist + Fixture data (Optional) Gerber + HP3070 Board Netlist + BoardXY Pin Location data Inserts Fixture data (Optional)
Automated	Gerber + ASCII CAD DATA Netlist + Fixture data (Optional)
Semi-Automated	Gerber + Netlist (No Pin Location Data) + Pick and Place or Centroid data Fixture data (Optional)
Manual	Gerber + Netlist (No Pin Location Data) data Fixture data (Optional)
Reverse Engineered from Gerber	Gerber

© 2000-2012 DeMille Research Inc.
TestSight is a Registered Trademark of DeMille Research Inc.
All other products mentioned on this site are trademarks of their respective owners.
Contact us at: (949) 462-9345, Fax: (949) 462-9346, E-Mail: salesinfo@testsight.com